검색결과 리스트
글
언제하지?? 아마 5월쯤 예정?
4월에 했음... 다시 해야 할 듯... 드레인플러그 워셔를 안 사서 원래 있는거 사용함.
4/11/2022
41,234마일
[공구]
- Filter Wrench (86mm가 맞음)
- 17mm Wrench (드레인 플러그용)
- T30 -> T27이 맞음 (언더 커버 제거용)
- T40 -> 6mm allen wrench이 맞음 (오일필터 제거전 잔유제거)
- Torque Wrench (오일필터 하우징 : 25.5Nm(18.8ft/lb = 19ft/lb) / 드레인 볼트 : 28ft/lb)
주문 : VCC RB20-2AE-SAE 0W20
[시작]
1. 차를 램프에 올리고, 공구 준비
2. 언더 커버 T30으로 제거 (10포인트)
키 한개가 없어져 있음 ㅠ
3. 17mm 소켓으로 제거
4. 6mm Hex 로 필터 잔여 제거후 필터렌치로 필터하우징 제거
5. 필터교체후 모두 체결후 새오일 5.5리터 정도 주입
끝
[참고]
https://www.swedespeed.com/threads/spa-xc90-diy-oil-change-with-pics.539386/
Steps:
- Loosen oil cap under the hood
- Remove the skid plate (10 T30 Torx screws, plus two spring loaded inserts; T27 also fits)
- Remove the oil drain plug (17mm hex bolt)
- Drain oil into suitable container
- Replace the drain bolt with new crush washer, tighten slightly past 'snug'
- Optionally remove the T40/6mm bolt from bottom of filter housing (to drain initial oil in filter) [Either T40 Torx or 6mm Allen wrench will fit]
- Remove the filter housing with the Volvo oil wrench
- Replace the filter within the housing
- Replace the large o-ring on the housing
- Replace the small o-ring on the T40/Allen bolt (bottom of filter housing) [If you removed the bolt]
- Apply oil to all o-rings!
- Replace the T40/6mm bolt [if you removed it]
- Screw in the filter & housing back into engine, I had to use the wrench again. Do not tighten very much! Let the o-ring do the work.
- Replace skid plate
- Fill engine with 6.2qt of specified oil [Note: 2016-2017 is 6.2qt; 2018 and newer are 5.9 qt]
RECENT COMMENT